SuZhou Tonkida Electromechanical Technology Co., Ltd Professional SMT whole line supplier

The power supply equipped with the job site of the SMT machine should be safe, the SMT machine generally uses compressed air and power supply as two layers of power, and the cooperation requirements of gas and electricity are more strict. Reflow welding machine, wave welding machine is a large power consumption equipment, to fully take into account their start, shutdown impact on other electrical equipment. Power equipment system selection of three-phase five-wire system is safe, some companies will protect grounding and neutral line two and one connection method there is a great sense of insecurity. Grid power supply quality is not high may cause damage to the production equipment, in some power grid voltage fluctuations are more serious areas, should be the chip communication voltage regulator power supply, in the equipment power wiring should pay attention to the balance of three-phase power supply load.

The design of the job site of the SMT machine must put the safe production in the first place. Because the mounting machine generally adopts the method of on-line installation, the load on the ground is relatively concentrated in the long length of the production line, and the total weight of a single high-speed mounting machine will exceed 6000kg after loading the Feeder, so the bearing capacity of the plant can have higher requirements. Usually, the mounting machine is installed in the plant, and the carrying capacity on the ground of the plant is not less than 7.5KN/m2, or even 10KN/m2. If the bearing capacity of the floor is too low, after the installation and use of the mounting machine for a period of time, the floor will simply deform or crack, affecting the reliability of the operation of the equipment and the degree of processing.

The machine requires the use of clean and dry compressed air, as a power source of compressed air should not only meet the technical requirements of the equipment in terms of pressure, flow and other parameters, but also before entering the machine to filter out the water, oil, dust and other impurities contained in the gas.

The individuality of electronic products leads to an increase in the demand for electronic voice, and the modularization and miniaturization of components are accelerated. Multi-variety, small-batch production mode is the challenge faced by most enterprises.